1926 Wood Flooring - Installation Of Ecofilm Set Underfloor Heating

All prices exclude VAT unless otherwise stated

Installation of Ecofilm Set Underfloor Heating

After preparing a smooth surface create a groove in the floor to accommodate the conduit for the floor probe.

Measure the area to be heated and fit the Depron insulation to the floor securely following the manufacturers instructions.

Roll out the lengths of EcofilmSet and trim to length as required. Never overlap the heating surfaces. Insulate trimmed ends as per instructions before taping the elements into position, taking care to locate the “cold tails”
on the wall nearest the thermostat connection box.

Cut away sections of the Depron to accommodate the
white sealing caps and cables of the element strips as well as the area where the floor probe will be located.

Tape over the cap ends and cables so that they do not
move out of position.

Check individual element length resistance using an Ohmmeter. Insert the thermostat floor probe into the protective conduit. A fully qualified electrician must
now make the final connections to the mains supply and install the thermostat in accordance with the current wiring regulations..

Note:

All installations require an RCD (residual current device) for safe operation.

The thermostat has a max load of 15Amp / 3450W at 230Vac.

All elements require connection to the thermostat via a standard junction box.

Finally:

Cover the total EcofilmSet installation with a layer of Flexel Polyester Vapour Barrier before laying the chosen floor covering

WARNING: ECOFILM IS NOT SUITABLE BATHROOMS